Door gaskets
Thread Starter
|
Laughing Gas
Joined: Dec 2007
Posts: 792
Likes: 3
From: Sandy Run SC
Door gaskets
I did not want to put the door gaskets from LMC on my truck. I looked around and finally found these peel and stick gaskets. I used the front part from LMC and used the peel and stick around the rest of the door. They seem to be working very good. Doors were not that hard to shut and are already getting better.
Thread Starter
|
Laughing Gas
Joined: Dec 2007
Posts: 792
Likes: 3
From: Sandy Run SC
Everybody I ask about door gaskets said the original type gaskets were a holy terror to ever get to work right. One of the men at the last car show I attended said he actually pulled his back off because he had to slam his door so hard. He had a good looking truck and said he paid someone to do the complete work over. I made the carpet holders and bottom strip out of a flat piece of aluminum and a angle piece. I sanded them down to remove the shine and clear coated them. Used two sided tape to attach the bottom piece.
