grease seal ?
Thread Starter
|
Senior User
Joined: Oct 2008
Posts: 121
Likes: 0
From: uniontown,pa.
grease seal ?
gotta 79 bronco full-time, am converting to lock-out. right side steering knuckle was blowed out and left side wheel bearings were bad so i'm replacing knuckle,wheel and spindle bearings,seals(both sides).during reassembly i kinda fogot where -FLOABT- the metal cup looking washer(?) goes in the assembly, it seems to fit between inboard (large) bearing and seal, is this right? whats the reason for this part? dude at work said leave it out, it has somthin to do with the full-time. i'm at a stand still, help me out.
Lead Driver
Joined: Sep 2002
Posts: 9,182
Likes: 12
From: Gateway to the West
Don't arbitrarily leave parts out! It goes inboard of the inboard (big) bearing. Its a dust/moisture cap. If I am interpreting your question and description of the part correctly, it should be labeled part 26 in this diagram. If not, perhaps you could post a photo of the part in question.
Thread
Thread Starter
Forum
Replies
Last Post
ulfie
1961 - 1966 F-100 & Larger F-Series Trucks
2
Apr 5, 2017 09:03 PM
dpilot83
1999 - 2016 Super Duty
8
Dec 23, 2015 09:43 AM
78_79ford
Explorer, Sport Trac, Mountaineer & Aviator
4
Apr 28, 2015 10:12 PM
Nickiboy
Clutch, Transmission, Differential, Axle & Transfer Case
3
Feb 15, 2011 10:38 AM
