Diff. location for upfitter-type switches?
Thread Starter
|
Junior User
Joined: May 2007
Posts: 78
Likes: 0
Diff. location for upfitter-type switches?
Am looking for ideas as to a clean location to install upfitter or other-type toggle switches into my '05 but don't want to use the factory location.
I have a manual transmission so can't use the 650 lower console.
Please and thanks.
I have a manual transmission so can't use the 650 lower console.
Please and thanks.
Cargo Master
Joined: Apr 2006
Posts: 3,215
Likes: 8
From: WV
I have a plan, but I'm not sure if its gonna pan out yet. I hope to mount three Carling switches to the left of the steering column, below the gauges.
Kind of in the opposite location as my rear wiper switch shown here
I have all the bits gathered, I just need to get some time and weather to do it. I'm also going to put one or two switches in the same spot beerstalker did. I'm a fan of that too
Kind of in the opposite location as my rear wiper switch shown here
I have all the bits gathered, I just need to get some time and weather to do it. I'm also going to put one or two switches in the same spot beerstalker did. I'm a fan of that too
Cargo Master
Joined: Apr 2006
Posts: 3,215
Likes: 8
From: WV
The three Carling switches are:
- wiper shaker (haven't installed that system yet but the switch is wired up & ready)
- backup camera enable
- heated mirror control
and the round rocker switch on the bottom is for a light in my truck cap.
There's a writeup on the way but here's a few teaser pics...
and for low range two wheel drive....
Thread
Thread Starter
Forum
Replies
Last Post
