Looking for a pulley...(?)
Thread Starter
|
More Turbo
Joined: Aug 2003
Posts: 606
Likes: 1
From: pleasanton, sfbay
Thanks, less underdriven than the march kit, but still a considerable amount smaller than stock. Is your kit blue or clear anodized? I thought about the trickflow/summit kits but didn't want blue pulleys 
Thread Starter
|
More Turbo
Joined: Aug 2003
Posts: 606
Likes: 1
From: pleasanton, sfbay
Hehe, not like its a horrible color, just not what I envision for my engine bay color scheme. So was there a noticeable improvement? No noticeable charging/cooling issues?
Posting Guru
Joined: Oct 2009
Posts: 2,066
Likes: 4
From: Rogue River, Oregon
If I remember right it was between 2 and 3 hrs for the bill. If you want to see it, go back a few years and the car was on the cover of Hot Rod magazine. It was an April issue and a silver and purple Hemi 'Cuda built by Kreations in Rio Dell, Ca. Lots of my work was on their website and not one part was credited to me, but rather their shop. Such is the life
Postmaster
Joined: Jan 2009
Posts: 4,558
Likes: 2
....The improvment was good , i have used them on two mustangs & my truck with no cooling or charging problems , the blue is ok with me, it matches some of my nitrous hoses , so i have two colors under the hood , red & blue , I use MSD ignition so its red , The pulleys blue , nitrous fittings blue fuel fittings red ..... Lew
Thread
Thread Starter
Forum
Replies
Last Post
SideWinder4.9l
Ford Inline Six, 200, 250, 4.9L / 300
3
May 24, 2011 03:41 PM
