Pushrod question?
Freshman User
Joined: Mar 2000
Posts: 40
Likes: 0
Pushrod question?
While I was looking at my heads I pulled the pushrods and noticed one was bent. The engine has around 200 miles on it. Is there much difference between pusrods brands and or alloys? I probably can't just by one, so I guess I will buy a set.
78 F-150 4x4
400 ci
78 F-150 4x4
400 ci
Junior User
Joined: Jan 2000
Posts: 57
Likes: 0
Pushrod question?
Any of the major cam manufacturers make reasonably priced push rods that are of good quality. Make sure you check to see what caused it to bend in the first place (valve lash, preload, bad lifter, etc) or it could happen again unless it was bent when installed.
Good luck!
Eric B.
Good luck!
Eric B.
Thread
Thread Starter
Forum
Replies
Last Post
