Help!
Thread Starter
|
Senior User
Joined: Jan 2009
Posts: 131
Likes: 1
From: Macungie Pa
Help!
I am trying to bolt my new driveshaft up on my truck finaly. I have the problem of the T19 2wd being a smaller U-joint that the driveshaft. Will the D50 TTB yoke bolt up to the T19? I am thinking if I remove both yokes and put the bigger one on the trans that I can make this work untill I can swap the 4wd T19 in.
Post Fiend
Joined: Oct 2007
Posts: 10,501
Likes: 5
From: Faibanks Ak.
Why they make ujoints that are different size on side to the other, if you have a decent parts man that will work with you he can find you one that fits. This is something that I have done several times.
Thread Starter
|
Senior User
Joined: Jan 2009
Posts: 131
Likes: 1
From: Macungie Pa
Ok I gotcha. I will take a look at my local store tomorrow.
Thank you.
Post Fiend
Joined: Nov 2003
Posts: 21,285
Likes: 15
From: Nutter Fort, WV
What year is the tranny and what was it in?
Then look at what year your drive shaft is?
You have a two piece driveshaft?
Does it have a slip yoke on the tranny or does the U joint bolt to a fixed joint and it has a slip joint in the drive shaft?
If fixed yoke, measure the cap diameter and cross length and take that info with you.
Then look at what year your drive shaft is?
You have a two piece driveshaft?
Does it have a slip yoke on the tranny or does the U joint bolt to a fixed joint and it has a slip joint in the drive shaft?
If fixed yoke, measure the cap diameter and cross length and take that info with you.
