T/C problem
Thread Starter
|
Senior User
Joined: Feb 2007
Posts: 223
Likes: 0
From: Kaukauna, WI
T/C problem
I kinda understands my torque converter is supposed to disengage when you touch the brakes (I'm assuming it's electrical and activated with the brake lights) but recently it disengages with the left signal light. It pulses with the flashing of the lights. Also it disengages when the headlights are turned on. Also this prevents the cruise control from working when the headlights are on.
May I have an electrical short in tail light wiring feeding back and signalling the t/c to disengage?
May I have an electrical short in tail light wiring feeding back and signalling the t/c to disengage?
Post Fiend
Joined: Jun 2002
Posts: 13,873
Likes: 3
From: Atlanta GA
I forget all the details (been 15 years) but, there was a recall/TSB related to this and I think it was the MAF or the cruise control module under the hood. It is not the wiring. In some cases it will provide unplanned acceleration in cruise mode and will not disengage.
If you search in the truck forum with "+cruise +recall" it will most likely pull up an old thread about it.
If you search in the truck forum with "+cruise +recall" it will most likely pull up an old thread about it.
Frmr Ford Trans Engr
Joined: Aug 1999
Posts: 24,722
Likes: 2,648
From: SE Florida
You have a problem with a brake light bulb on the rear of the truck. One or more is blown, or shorted to the taillight filament. It is probably the left side, though the center one can do this, too.
Thread
Thread Starter
Forum
Replies
Last Post
thatsrealnice
1973 - 1979 F-100 & Larger F-Series Trucks
16
Jul 31, 2020 06:00 PM
jerseymike
1968-Present E-Series Van/Cutaway/Chassis
2
May 5, 2016 11:10 PM
