Are replacement CDR boots available?
Thread Starter
|
Postmaster
Joined: Oct 2005
Posts: 3,724
Likes: 0
From: Clarksburg WV
Are replacement CDR boots available?
The one on my truck had a big crack in it last year when I took it off to clean it, so I attempted to fix it with JB weld...no go there, it has cracked through the JB Weld and is leaking.
I'm not holding my breath, but can I get this boot anywhere?
I'm not holding my breath, but can I get this boot anywhere?
Thread Starter
|
Postmaster
Joined: Oct 2005
Posts: 3,724
Likes: 0
From: Clarksburg WV
Dave, not sure which part you're talking about...I need the "boot" where it goes into the valve cover. Mine looks terrible, typical old cracked rubber.
This is for a turbo engine, of course...is the boot the same as the one for NA engines? I bet it isn't.
This is for a turbo engine, of course...is the boot the same as the one for NA engines? I bet it isn't.
Elder User
Joined: May 2004
Posts: 790
Likes: 0
From: Danville, Pa
There's 2 parts there. A rubber grommet that is attached to the valley pan, and a rubber tube that clamps onto the CDR and slides into the grommet. I just used a piece of 1" rubber line I had sitting around, along with a 1" SS crimp clamp like whats used on PEX when I replaced my Valley pan.
