92 Changed steering column wont start
Thread Starter
|
Freshman User
Joined: Apr 2003
Posts: 40
Likes: 0
92 Changed steering column wont start
I just swapped out steering columns on my truck. It is a 92 F150 with a manual transmission. The steering column was for an automatic however. After putting it together the starter would turn over, but the truck would not start. I looked closer and noticed a wire connector not connected to anything. I took a couple of pictures, but I do not have enough post yet to put pictures on the site. The connector has 3 wires to it, a white/green wire, a white/brown wire and a red wire in the middle with "A" "B" "C" on the connector. It branches off from the group of wires going to the turn signal and emergency flasher. Any ideas?
After further review, it appears as though some folks have had to adjust the ignition switch. Could this be the problem? I would think if the starter is turning, the truck should start.
After further review, it appears as though some folks have had to adjust the ignition switch. Could this be the problem? I would think if the starter is turning, the truck should start.
Thread
Thread Starter
Forum
Replies
Last Post
lisagoud
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
2
Dec 6, 2010 07:24 PM
fun_suv
1997 - 2006 Expedition & Navigator
4
Jul 19, 2010 12:22 AM
Calfdemon
1967 - 1972 F-100 & Larger F-Series Trucks
9
Jun 25, 2010 07:07 PM
stang_crazy_gt
1967 - 1972 F-100 & Larger F-Series Trucks
2
Oct 25, 2007 12:14 PM
