Wire Identification
Thread Starter
|
Tuned
Joined: Dec 2005
Posts: 424
Likes: 2
Wire Identification
I am going to be installing a Valentine One Radar Detector in my 2007 Screw. I am mounting the detector just below the rear view mirror. I am going to hard wire the unit into the wiring harness so it comes on with the switch. Can anyone tell me which would be the best wire to splice into and where is it located for easy access?
Thanks,
srb1194
Thanks,
srb1194
Elder User
Joined: Dec 2004
Posts: 892
Likes: 1
From: Las Vegas
I would wire it into you're rear view mirrior. That will keep things nice and clean since you are going to be mounting it right there.
Pin 3 on the connector face is the power wire. PM me if you need a full size pic.
Pin 3 on the connector face is the power wire. PM me if you need a full size pic.
Thread
Thread Starter
Forum
Replies
Last Post
