EMT steps
Thread Starter
|
Senior User
Joined: Nov 2007
Posts: 337
Likes: 0
From: Mt. Airy MD
EMT steps
https://www.ford-trucks.com/forums/a...pictureid=3193
Well since I got the lift on some of the guys who work with me have been complaining about getting into the truck(factory steps rusted through and broke off) So I grabed some 3" EMT(electric metalic tube) and welded this up. I used the factory hangers from the original steps which I might change because its a tad to low for my taste. Didn;t turn out that bad for some scrap pipe and $50 for the 90's. I coated them with herculiner spray on bed coating
Thread Starter
|
Senior User
Joined: Nov 2007
Posts: 337
Likes: 0
From: Mt. Airy MD
Here is a pic ofthe pipe. About an 1\8" side wall. 3" EMT is almost 3.5 outside dimension
and a couple more
https://www.ford-trucks.com/forums/a...pictureid=3195
https://www.ford-trucks.com/forums/a...pictureid=3196
How do you guys post your pics in the thread? I see the button up top to insert a pic but all that shows up is a small box like in my first post.
