finding gear ratio ?
Lead Driver
Joined: Nov 2003
Posts: 6,900
Likes: 3
From: Campbell River, B.C.
Welcome to the forum.
The easiest way would be to look at the door sticker of the truck and find the axle code. If you post the code here, we can decode it for you or if it is one of these model years you can look it up yourself.
https://www.ford-trucks.com/article/...de_Chart_.html
The easiest way would be to look at the door sticker of the truck and find the axle code. If you post the code here, we can decode it for you or if it is one of these model years you can look it up yourself.
https://www.ford-trucks.com/article/...de_Chart_.html
Lead Driver
Joined: Nov 2003
Posts: 6,900
Likes: 3
From: Campbell River, B.C.
Most of the time its 2 digits, but I think some older years had only 1.
This diagram may help figure it out:
https://www.ford-trucks.com/article/...r_Decoder.html
This diagram may help figure it out:
https://www.ford-trucks.com/article/...r_Decoder.html
Ford Parts Specialist
Joined: Nov 2006
Posts: 88,826
Likes: 787
From: Simi Valley, CA
Look for the AXLE code.
The AXLE code was two digits thru 1972 on F100/350's.
After 1972, it can be two or three digits.
The 3rd digit either decodes the front axle if 4WD, or denotes if P/S or Tilt Wheel is present.
If the first digit of the AXLE code is a letter, it has Limited Slip, if a number it doesn't.
The AXLE code was two digits thru 1972 on F100/350's.
After 1972, it can be two or three digits.
The 3rd digit either decodes the front axle if 4WD, or denotes if P/S or Tilt Wheel is present.
If the first digit of the AXLE code is a letter, it has Limited Slip, if a number it doesn't.
