E4od
Thread Starter
|
Senior User
Joined: Aug 2008
Posts: 201
Likes: 0
E4od
i have been having shifting probs with my 95 bronco 351 e4od, i put a new speed sensor in it n bought a code reader after i put the sensor in it i used the code reader, n got 452 vehicle speed sensor signal falt... what do i do
Thread Starter
|
Senior User
Joined: Aug 2008
Posts: 201
Likes: 0
Thanks Mark,
i checked the wires but i didnt see anything wrong with them should i pull them out of the plastic caseing from the sensor?
and it only shifts hard after school or in stop n go driving
i checked the wires but i didnt see anything wrong with them should i pull them out of the plastic caseing from the sensor?
and it only shifts hard after school or in stop n go driving
Frmr Ford Trans Engr
Joined: Aug 1999
Posts: 24,730
Likes: 2,658
From: SE Florida
With an ohm meter. You need to disconnect the connector at the PCM and at the trans. You read the ohms in the wire between the two connectors. If it's more than a couple ohms the circuit is bad. You also check for continuity from each wire to ground. There should be no continuity.
