3.0L mods
Thread Starter
|
Junior User
Joined: Sep 2006
Posts: 75
Likes: 0
3.0L mods
Hey guys i was wondering where to get mods for my 06 ford ranger 3.0L for cheap Im starting with intake and exhaust but also i was wondering wethere or not to change the fan to electric and change out the under drive, and posibbly chip it im nah looking to go forced air yet and have a borla muffler just sitting around my garage that i was thinking of getting a coustom set uo form the cat flange back
Post Fiend
Joined: Jan 2005
Posts: 7,147
Likes: 0
The 3.0 isn't a very mod friendly engine. The bama engine programer will help the most for about 10 hp and 15 foot pounds. BamaChips Tuning. Underdeive pullies will be your second biggest bang for the buck at around 5-7 hp. An intake and catback might get you 3-4 hp. However, it will give you an awesome sound, the intake growls and the catback rumbles. Forced induction is the only meaningful way to get power from these engines and as of right now, there are no kits on the market, you will have to build your own. The best way to get power from your 3.0, is to swap it out for a 5.0.
Post Fiend
Joined: Oct 2005
Posts: 5,242
Likes: 0
From: Kiev, Ukraine
There were perfomance camshafts and dual valve springs available on market. Engine revs up faster, more sharp but 10-15 HP gane only. It is also possible to increase compression up to 1:13 and run oct 95 gas. +5Hp. But oct.95 is too expencive
Thread
Thread Starter
Forum
Replies
Last Post
Rob_Diesel
1994.5 - 1997 7.3L Power Stroke Diesel
4
Apr 30, 2017 11:13 AM
