rollcage with seat mounts
Thread Starter
|
Cargo Master
Joined: Mar 2003
Posts: 2,333
Likes: 296
rollcage with seat mounts
I'm seriously considering the ProtoFab family roll cage with dash grab bar, harness mounts and built in seat mount hardware.
Is this going to place the seats higher or lower than if the seats were mounted to the floor?
Is this going to place the seats higher or lower than if the seats were mounted to the floor?
Senior User
Joined: Aug 2003
Posts: 183
Likes: 1
From: Chestermere,Alberta
Depends on the seats you go with. Stock seats will sit the same. Aftermarket will sit close to the same hight and wreaking yard seats....well you may have to play with it to sit where you like.
Thread Starter
|
Cargo Master
Joined: Mar 2003
Posts: 2,333
Likes: 296
I'll be going either Beard Street or Super, Mastercraft Sportsman or Corbeau Baja.
I'm 6'4" and I don't want to be looking over the top of the windshield while driving down the road.
Thanks for the input.
Unfortunately, with the economic turndown, I'm going to have to put it off just a little bit longer, yet again.
I'm 6'4" and I don't want to be looking over the top of the windshield while driving down the road.
Thanks for the input.
Unfortunately, with the economic turndown, I'm going to have to put it off just a little bit longer, yet again.
Thread
Thread Starter
Forum
Replies
Last Post
hwyhogg
1948 - 1956 F1, F100 & Larger F-Series Trucks
12
Dec 6, 2009 10:15 AM
