Brush Guard
Thread Starter
|
New User
Joined: Jun 2008
Posts: 22
Likes: 0
From: beer city usa
Brush Guard
I bought a used brush guard that is suposed to mount directly onto my truck by bolting to the bottom of the frame. there are two holes inline on both sides. My question is if anyone has any experience with this and if a U bolt is what is normally used.
Thanks.
Thanks.
Thread Starter
|
New User
Joined: Jun 2008
Posts: 22
Likes: 0
From: beer city usa
Thanks for the info. What I ended up doing was buying some large straight nuts and bolts. The tricky part was getting them inside the frame. I found a larger hole further back on the frame and used a piece of wire wrapped around the bolt to push it down to the hole in the frame and drop it in then after i put the nut on a little i yanked the wire off of the bolt and repeated till done. I also ended up noticing that the front of the frame would be open if you removed the front plastic air dam.
