1977 Highboy
Thread Starter
|
Junior User
Joined: May 2008
Posts: 51
Likes: 0
thanks
Kind of a random question in this thread.
You might actually get a better response if you start a new thread.
Anyway, are you asking about a crossmember? These are riveted in, and can be removed. These are easily replaced, and can be bolted in. Angle iron might get you by, but I fear it might not be the cleanest or best way to fix this.
You might actually get a better response if you start a new thread.
Anyway, are you asking about a crossmember? These are riveted in, and can be removed. These are easily replaced, and can be bolted in. Angle iron might get you by, but I fear it might not be the cleanest or best way to fix this.
Post Fiend
Joined: Jul 2006
Posts: 6,948
Likes: 44
No worries man. I just pointed this out, so you can title your thread and others can reply. This will maximize your exposure, and you will obtain far better results.
