Pushrod length
New User
Joined: Jun 2008
Posts: 3
Likes: 0
If your running a solid cam you dont have as much room as you would with a hyd cam. I would make sure that when you find a certain length you check it on multiple cylinders to make sure you come up with the same number. It could screw ya up when you set your lash.
Post Fiend
Joined: Jan 2001
Posts: 5,121
Likes: 1
From: Springfield, VA
Fortunately for now I will be running a hyd cam, my only concern will be with the change to studs and the harland sharp rollers, what will I need for pushrod length.. I need to put her together and see....
Thread Starter
|
Post Fiend
Joined: May 2004
Posts: 5,277
Likes: 0
From: St George, SC I-95
thats what sucks about it.
you have to assemble over half the engine then wait 2 days for jegs/summit to send you the pushrods you need. Other option is pay $35 to have them overnighted but youre still waiting.
you have to assemble over half the engine then wait 2 days for jegs/summit to send you the pushrods you need. Other option is pay $35 to have them overnighted but youre still waiting.
Junior User
Joined: Oct 2007
Posts: 83
Likes: 0
wow , interesting responce from lots of people, just get a adjustable pushrod checker from any quality parts supplier and try to keep the roller tip onto the valve stem as close
possible to the centre of the valve stem during complete engine rotation , this is a
sometimes time consuming job, pushrod length/rocker arm height/ length are all things
that can change angles so have fun and sit down and get it done
possible to the centre of the valve stem during complete engine rotation , this is a
sometimes time consuming job, pushrod length/rocker arm height/ length are all things
that can change angles so have fun and sit down and get it done
Thread
Thread Starter
Forum
Replies
Last Post
alpha/omega
Offroad & 4x4
295
May 15, 2014 09:36 PM
STGFordCrazy04
South Carolina Chapter
3
Jul 25, 2008 10:57 AM
STGFordCrazy04
Clutch, Transmission, Differential, Axle & Transfer Case
9
Aug 31, 2005 07:26 PM
