New Problem, Wiring!
Thread Starter
|
Senior User
Joined: Sep 2007
Posts: 195
Likes: 0
From: Redwood Valley, CA
New Problem, Wiring!
In the midst of putting my fuel leak project back together I have just discovered that I have a burnt connector on my main wiring harness to the valve cover gasket. Can you get a new plug end for the main harness or do you have to replace the whole harness? I have recently replaced all of the glow plugs with factory IH ones and Replaced the UVC harnesses last year. Looks like my project isn't over yet.
Justin
Justin
FTE Leadership Emeritus
Joined: May 2001
Posts: 13,653
Likes: 6
From: Cabot, Arkansas
Posting Guru
Joined: Nov 2003
Posts: 2,214
Likes: 0
From: THUNDER BAY
I would check all the glow plugs and uvc harnesses I know you said you just changed them but this happened to me I put new glow plugs in and 4 went bad in 2 or 3 months and burnt my harnesses.
bet your uvc looks a little like this
notice something missing LOL
bet your uvc looks a little like this
notice something missing LOL
Thread Starter
|
Senior User
Joined: Sep 2007
Posts: 195
Likes: 0
From: Redwood Valley, CA
So, I found the problem. It turns out the valve cover gasket shorted out on one of the glowplug pins and screwed up everything in that connector. I got the new plug kit from IH and put on a spare valve cover gasket I had around the shop. Runs great. Thanks for all the help.
Justin
Justin
