Does anyone have a bearing retainer off of a T-98 4 speed they will sell and ship to me by chance? I have a Borg Warner T98 4 speed out of my 56 Ford truck. The bearing retainer is the part that bolts to the front of the trans with 4 bolts and the throwout bearing slides on. I'm going to check around over the weekend too and see what I can dig up.

 

Too bad you're not closer!

I have a whole T-98!

Cheers,


Rick

 

im putting a t-98 in my 53 to replcae the light duty 3 speed in it and was questioning about parts . the obvious was napa , then the guys suggested anyone of the many jeep aftermarket parts people as the jeeps used the t-98's for years beyond ford . hope that helps .

 

B6C-7050-A .. Bearing Retainer ~ 4 1/8" overall length / 5.24" flange diameter / 3 49/64" flange inside diameter

Fits: All T-98's 1956/66 / some T-18's 1967/72.

I checked the following two obsolete Ford parts sellers websites: nothing.

Green Sales / Dennis Carpenter

 

Job lot or Chucks Trucks might have this. Chucks is where I got my T-98 for my F-5

 

I have one that I will seperate. If you still need it PM me .

Kevin Bigwin