ALmost done
Thread Starter
|
Logistics Pro
Joined: Jan 2005
Posts: 4,129
Likes: 4
From: Brandon, MB
ALmost done
I was going to wait until I was actually finished installing the new clutch, but I didn't get it done last night. It just got too cold out there. Anywa, it's in, I just have to tighten the tranny mounts, put the driveshaft in and then reinstall the shifters. I'll be taking her for a rip today and I'll post again once I do. Hold on to your butts! 
Thread Starter
|
Logistics Pro
Joined: Jan 2005
Posts: 4,129
Likes: 4
From: Brandon, MB
Got 'er done! Haven't gone for a ride yet. Had to have lunch. I'm heading to town right away. I did move it around the yard. I had to wiggle the boat back into the barn now that the truck is out. The clutch is a LOT lighter and there's no violent shaking at idle. I also got my E-brake working again. IT was just a disconnected connecter when I did the injectors.....Ooops. Off I go to light some tires!!!!
I'm heading to town right away. I did move it around the yard. I had to wiggle the boat back into the barn now that the truck is out. The clutch is a LOT lighter and there's no violent shaking at idle. I also got my E-brake working again. IT was just a disconnected connecter when I did the injectors.....Ooops. Off I go to light some tires!!!!
.....
Thread
Thread Starter
Forum
Replies
Last Post
