AIH delete

Reply Subscribe

Thread Tools

Search this Thread

Jan 6, 2008 | 03:22 PM

Benny2002

Thread Starter

Posting Guru

Joined: Feb 2007

Posts: 1,146

Likes: 3

From: Bradenton FL

AIH delete

Did the delete a while back and hadnt pulled codes tell the overdrive light flashed for a bit. Pulled 0451 i think it was, something to do with low input from the heater, i thought by pulling the wires off of it no codes would show up? Is there something else i can do to not have this code or is it ok as is.

Jan 6, 2008 | 03:45 PM

mech2161

Posting Guru

Joined: Oct 2004

Posts: 2,244

Likes: 0

From: Morgantown WV

It will set a code but not a light. There is a resistor that you can install to fool the code. Not sure what the value of the resistor is.

Jan 6, 2008 | 03:52 PM

Benny2002

Thread Starter

Posting Guru

Joined: Feb 2007

Posts: 1,146

Likes: 3

From: Bradenton FL

With that code set does it mess the PCM mess with the fuel?

Jan 6, 2008 | 03:54 PM

Orezona

Postmaster

Joined: Oct 2004

Posts: 3,767

Likes: 1

Pocket ran a thread a little while back on that resistor. I don't remember what he ended up with. Here is the device Mech is talking about http://www.puredieselpower.com/catal...541-p-109.html