Hello
Thread Starter
|
New User
Joined: Dec 2007
Posts: 4
Likes: 0
Hello
Hey I'm pretty new to this so don't be too rough but I have 1991 Ranger with 6 inches of lift pushing 33x12.50R15 and a 5 speed manual tranny...but as usual a problem with it. It is stock with the 2.3L engine and I'm looking for more power and maybe someone could help me get that extra little boost I'm looking for in my truck..
Carpenter Local 745
Joined: Apr 2006
Posts: 5,794
Likes: 11
From: on da beach
Welcome to FTE ranger721,
Besides dropping a V8 in your ranger, you can always replace your rings and pinions - if you have not done so already.
You may have changed the final drive ratio on your ranger, new gearing can bring the RPMs back to the engines powerband.
Besides dropping a V8 in your ranger, you can always replace your rings and pinions - if you have not done so already.
You may have changed the final drive ratio on your ranger, new gearing can bring the RPMs back to the engines powerband.
Thread Starter
|
New User
Joined: Dec 2007
Posts: 4
Likes: 0
What if i just wanted a 2.9 or 4.0 in my truck, my brother had the 2.9 in his '89 Bronco II and had 31's and his didn't lack power so would it be worth it to just go up to the 2.9 or 4.0 and where could I find one??
Carpenter Local 745
Joined: Apr 2006
Posts: 5,794
Likes: 11
From: on da beach
1. Go to the Ranger forum and post your questions about swaps.
2. You can place an ad for a 4.0 in the FTE classifieds.
3. You can probably find all the 4.0 parts at an auto recycler in your area.
4. James Duff
http://www.jamesduff.com/broncoII/v8conversion.html
2. You can place an ad for a 4.0 in the FTE classifieds.
3. You can probably find all the 4.0 parts at an auto recycler in your area.
4. James Duff
http://www.jamesduff.com/broncoII/v8conversion.html
Thread
Thread Starter
Forum
Replies
Last Post
