Bambi-Vision with newer part number relay ???
#1
Bambi-Vision with newer part number relay ???
I have a '06 Scab that I just went out to do the Bambi-Vision mod on. I found that I have a 4 pin relay with a new part number "4fit-148192-aa" as opposed to the 5 pin "f57b-148192-aa" in the http://www.landstromsfoundry.com/Tec...Foglights.html write up.
I'm not so sure it is safe to proceed and assume that the eliminated pin was unused. Has anyone ran into this before? Thanks for your assistance.
I'm not so sure it is safe to proceed and assume that the eliminated pin was unused. Has anyone ran into this before? Thanks for your assistance.
#2
#3
#4
#5
#6
Originally Posted by brad3384
I am thinks about getting the ultra light bulbs to go in the headlights and fog lights. I hear they are bad to the bone.
I did just put some of the Silverstar front turn signal bulbs in to lose the "egg yolk" look on the nose of the truck. My father like the improvement so much he went out and bought Silverstars for his Ranger too.
Regards,
Craig
Thread
Thread Starter
Forum
Replies
Last Post
ToMang07
Maine Chapter
215
12-02-2014 02:47 PM
akamacgyver
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
14
09-02-2012 01:39 PM