2wd front radius arms???
Thread Starter
|
Senior User
Joined: Jun 2007
Posts: 239
Likes: 0
2wd front radius arms???
I'm needing 2 new front radius arms (1 is bent downward) for my '74 F-100 2wd, I may have found a pair out of a '70 but the gentlmen says there cast and mine look like stamped steel. Can anybody shed light on this? Niether of us know for sure.
Also a note: my ride is lowered (whole lot a questions with that) is it possible that this is bent intentionally for alignment purposes? Tires seem to where fine (for a twin I-beam anyway).
Also a note: my ride is lowered (whole lot a questions with that) is it possible that this is bent intentionally for alignment purposes? Tires seem to where fine (for a twin I-beam anyway).
Fleet Mechanic
Joined: Mar 2004
Posts: 1,398
Likes: 17
From: Hesperia, CA
Yours are stamped. They commonly bend them to set the caster on the front end. As far as the forged ones fitting I am not sure. Get under there and start measuring. That should tell you. The forged ones definitely look stronger. whether they are or not is a different question.
