Changing Pinion Yoke????
Thread Starter
|
Senior User
Joined: Oct 2004
Posts: 342
Likes: 0
From: Gainesville, Georgia
Changing Pinion Yoke????
Hi Guys,
I have a quick question. Currently I have a Ford 9" rear end and am running a 1310 (3 1/4") series yoke and u-joint. If I wanted to change the pinion yoke to a 1350 series yoke and u-joint; what all needs to be done. Is it as simple as taking the pinion bolt off and pulling the old yoke off, then putting the new one on and torquing it back down or do I need new crush sleeves, seals, etc. ????
Thanks.
I have a quick question. Currently I have a Ford 9" rear end and am running a 1310 (3 1/4") series yoke and u-joint. If I wanted to change the pinion yoke to a 1350 series yoke and u-joint; what all needs to be done. Is it as simple as taking the pinion bolt off and pulling the old yoke off, then putting the new one on and torquing it back down or do I need new crush sleeves, seals, etc. ????
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
cdwoodcox
Clutch, Transmission, Differential, Axle & Transfer Case
2
Oct 9, 2011 04:26 PM
abelmoreno
1987 - 1996 F150 & Larger F-Series Trucks
1
Oct 2, 2010 05:13 PM
cdherman
Clutch, Transmission, Differential, Axle & Transfer Case
4
Feb 23, 2004 02:23 PM
cdherman
1961 - 1966 F-100 & Larger F-Series Trucks
2
Feb 22, 2004 10:03 PM
