removing glow plug/injector harnass
Thread Starter
|
Senior User
Joined: Nov 2005
Posts: 308
Likes: 0
removing glow plug/injector harnass
Today I finally had a break from college, so I tried to test the reistance of my glow-plugs to get to the bottom of my hard start issue, but I coundn't get the harnasses disconnected. Is there a trick to getting them off? I tried pushing on the high center portion of the harnass, but I could not budge it. Went to try the passenger side, and there was no center part, but harnass seemed very snug! Thanks in advance for the help!!
Posting Guru
Joined: Jan 2007
Posts: 2,174
Likes: 1
From: Millersburg, OR
It should just snap in right where the wires meet the valve cover... There is a spot to push down on and pull...
Just don't break it they are expensive to replace.
this is easy to do... don't take to the dealer.. you should be fine.
The plugs just pull off the glow plugs pretty easy. You may not even need to unhook it. Just unhook the batteries??
Just make sure they are on there nice and tight when you are done. Use some needlenose pliers to push them down all the way...
Just don't break it they are expensive to replace.
this is easy to do... don't take to the dealer.. you should be fine.
The plugs just pull off the glow plugs pretty easy. You may not even need to unhook it. Just unhook the batteries??
Just make sure they are on there nice and tight when you are done. Use some needlenose pliers to push them down all the way...
Thread
Thread Starter
Forum
Replies
Last Post
2007sporttrac
Electrical Systems/Wiring
1
Apr 19, 2015 04:24 PM
Clint40
1999 - 2003 7.3L Power Stroke Diesel
1
Nov 11, 2007 04:30 PM
