switch
Elder User
Joined: Dec 2004
Posts: 891
Likes: 1
From: Toulon,Il.
I would take it back and get the one that doesn't have the switch (push/pull),just a dial. As for which of tne three terminals if the shaft is pointed at you it will be the center&right one for a clockwise rotation to increase resistence .Solder wires into terminals then run them out to icp & splice into harness just as c00n's photo. 16-18 guage wire is easist to use. Hope that's clear.
BTW switch on the one you have is for on/off like older tv's had-on/off& volume one ****.
BTW switch on the one you have is for on/off like older tv's had-on/off& volume one ****.
Lead Driver
Joined: May 2007
Posts: 8,608
Likes: 13
From: Belair md
definatly dont want the on-off switch when it is wired inline, thats a guranteed check engine ligth and stall, you would be turning the icp signal off going to the pcm, that wouldnt be good, all you need is a 3 prong potentiometer, you can wire it 2 ways, turn right to raise resistance, or turn right to lower,, i would wire it turn right to raise as that wil be turning up the power
Elder User
Joined: Dec 2004
Posts: 891
Likes: 1
From: Toulon,Il.
FTE Stories
Ford Trucks for Ford Truck Enthusiasts
Top 10 Most Expensive Ford Trucks Ever Sold on Bring a Trailer
Joe Kucinski
2027 Ford Super Duty Buyer's Guide (Every Model, Engine, & Package)
Brett Foote
Top 10 Ford Truck Tragedies
Joe Kucinski
AEV FXL Super Duty - the Super Duty Raptor Ford Doesn't Make
Brett Foote
Lobo Vs Lobo: Proof the F-150 Lobo Should Be Even Lower!
Michael S. Palmer
Ford's 2001 Explorer Sportsman Concept Looks For a New Home
Verdad Gallardo
10 Best Ford Truck Engines We Miss the Most!
Joe Kucinski
2026 Shelby F-150 Off-Road: Better Than a Raptor R?
Brett Foote
2027 Super Duty Carhartt Package First Look: 12 Things You NEED to Know!
Michael S. Palmer
FOREIGN GURU
Joined: Jul 2006
Posts: 7,655
Likes: 7
From: Celaya, Gto. MX
Ok, thanks, I checked it and is 10K. I was thinking if it is in the off position it could be against steal (robbery), that could be a good idea? or it could screw something (like PCM)? whats your opinion. Maybe I should buy only one with the dial.
Lead Driver
Joined: May 2007
Posts: 8,608
Likes: 13
From: Belair md
i think you will find that when you pu**** to off you will lose the circuit, definatly dont want that, if you can wire it so that is unaffected by the on-off feature then it will work fine,
no luck on the mods tonight, got sidetracked as usual, too much goin on here still, didnt even get to change the oil again.....the hood was up at least tonite....so close
no luck on the mods tonight, got sidetracked as usual, too much goin on here still, didnt even get to change the oil again.....the hood was up at least tonite....so close
