#341331 Crane cam
Thread Starter
|
New User
Joined: Jul 2007
Posts: 14
Likes: 0
#341331 Crane cam
Just received my new cam from a freind of mine for my 390 truck, going to switch it over from hyd to adj. Been gettin lots of advise from freinds on what to use for rockers, springs, pistons,lifters,push rods etc. Its going to be a daily driver and I'll be doing some mud racing. I've got flowtech headers and Holly 3310. Now I'm asking some advise from the experts here and maybe part #s.
Thanks-Jay
Thanks-Jay
Fleet Mechanic
Joined: Aug 2007
Posts: 1,816
Likes: 248
From: Piney Woods of East Texas
As far as rockers you may want to look at Holland Sharps Rollers, the a little cheaper.
If I can figure out how to upload pictures on this site, I have a set on my 360.
If I can figure out how to upload pictures on this site, I have a set on my 360.
Last edited by blue68f100; Aug 13, 2007 at 04:11 PM.
Lead Driver
Joined: Jan 2003
Posts: 9,893
Likes: 12
From: Ohio
I run stock Fomoco rockers/pushrods on two of my hot rods. Depending on the cam, you could too. Mine are all adjustables as I run solids. Solids are fine, but yes they do require a bit of maintenance probably once a year to check lash. You do have to like the little ticky/ticky from mechanicals too! If you like quiet motors, then go hydraulic. I think my one cam is .590 lift(or so-been too many years since I had cam card). I turn it 6000 rpm without issues for alot of years now. I suppose if you have the money for aftermarket stuff, that's good.
