Water pump question
Thread Starter
|
New User
Joined: Nov 2006
Posts: 4
Likes: 0
Water pump question
Putting an engine out of an 86 Crown vic in a 93 F250, was doing all my research to see what all needs to be swapped from the 93 motor. Only thing im really seeing thats going to be a problem is the water pumps. can I use the 86 pump with the 93 pulley and have it line up right or will it even bolt onto the older pump? I know i have to change the upper and lower intakes, exhaust manifolds, distributors, use the 93 starter, Maybe flywheel, havnt looked to see what trans is in the truck yet, and all the accy's and brackets off the 93. Does anybody know right off anything else that will need changed or might not work? Will the accy brackets bolt on to the older block? The 86 motor is fuel injected too with the two piece intake, both are 302's. need any more info to tell me then let me know. Thanks ahead of time.
Tuned
Joined: Jul 2007
Posts: 289
Likes: 0
From: So. Cal.
I don't know much about what you're doing but I have read that some water pumps turn the oposite way. Somebody also mentioned changing the housing the pump bolts to. I think that's the timing chain cover.
Good luck.
Good luck.
Thread Starter
|
New User
Joined: Nov 2006
Posts: 4
Likes: 0
Ya I changed the timing covers, put an new timing chain in, water pump etc and got it runnin. everything bolted right up after the guy brought me all the right parts. Now im workin on a damn windstar..... stupid plastic intakes.... will be makin a post on that later.
