Fender alignment on 94
Thread Starter
|
Elder User
Joined: Jul 2005
Posts: 662
Likes: 0
Fender alignment on 94
Hi all. I have a question about aligning the fender and cowl panel on my 94. The PO apparently wasn't a very good driver or just drove the mess out of it. The driver's side fender is leaning back at the top at the driver's door and the cowl panel at the back of the hood has a gap of about an inch on the driver's side. The passenger's side lines up fine but the gaps are driving me nuts. Where the heck are the bolts to move the fenders around with? I've looked and found some, but obviously not all of them. Please help save what's left of my sanity. 
Hotshot
Joined: Jul 2002
Posts: 14,285
Likes: 12
From: Bend,OR
i think if you open the door look inside the were fender meets the door, also look on the underside of the fender near the door. you may have to remove some of the plastic innerfender. you should only have to losen the bolts to allow adjustment
