does anyone have one for a 97? I am in the process of installing electric windows, locks, mirrors off a 97 on my 94. I need to fabricate a wire harness and I need the codes for the wires. I was not able to pull the dash and get the loom when I got this stuff so all I have is the ends that go in the kick panels. Already got the seats but need to finish up the rest.

Any help will be appreciated.

 

I'm not so sure that it'll be so simple of a switch. After 94 they switched to OBDII, changed the entire interior and computer. Pretty much everything but the metal on the body/frame itself. There might be a way, but only after extensive research to do it. It may be cheaper/easier to buy brand new aftermarket stuff. They can come with the switches and remotes, everything to get it done on its own without worrying about the trucks factory wiring harness. I may be mistaken tho and they may have kept more than I realize.

 

the interiors are almost identical, I have the complete doors it was a roll over so I have all the switches etc. Just need a wire diagram to fabricate from. WOnt have all the little Gem boxes but can live without them.

 

Haynes manual #36071 has both diagrams. If you can't get the manual (Autozone carries mostly Haynes in my area), I could e-mail you the diagrams. jd

 

JD pm'd ya if ya could send the diagrams. Have a GP manual for all trucks no wire diagrams however.

Appreciate it.

 

Sent. jd

 

thank you, went to AZ to check out the manual, the new ones same number does not have these!

Also found they had the haynes for the supereduty style f150 (sons truck), and the new F250/350 with the diesel engines. so ended up buying all 3!

Thanks again.