Intake Elbow?
Senior User
Joined: Aug 2006
Posts: 234
Likes: 0
From: NW Austin
My mechanic installed the 05-07 Elbow from Aaron @ Intake Elbows in my 2004 PSD.
It took about 10 mins for him to remove that piece of.... whatever that thing is..off. Mine did have the pins and was operating to my knowledge.
Very simple install.
As others have already said, Wow. This has to be the cheapest, best, ( biggest benifit for lowest cost ) you can do to 03-04. ( In my opinion )
Much quicker spool up, lower boost pressure, and slightly lower EGT ( it seemed, have not tested to much since last night )
Overall Power delivery is much smoother, and more powerful from idle ( 640 rpm) to 2800 rpm.
( Do not often run over 2800rpm )
Even though I had the Edge Juice set to 0 ( stock) It felt as if I was on Level 1..
Looks cool too.
Take Care,
It took about 10 mins for him to remove that piece of.... whatever that thing is..off. Mine did have the pins and was operating to my knowledge.
Very simple install.
As others have already said, Wow. This has to be the cheapest, best, ( biggest benifit for lowest cost ) you can do to 03-04. ( In my opinion )
Much quicker spool up, lower boost pressure, and slightly lower EGT ( it seemed, have not tested to much since last night )
Overall Power delivery is much smoother, and more powerful from idle ( 640 rpm) to 2800 rpm.
( Do not often run over 2800rpm )
Even though I had the Edge Juice set to 0 ( stock) It felt as if I was on Level 1..
Looks cool too.
Take Care,
Thread
Thread Starter
Forum
Replies
Last Post
Storm
6.0L Power Stroke Diesel
29
Mar 5, 2007 01:32 AM
