distributor question
Thread Starter
|
Senior User
Joined: Aug 2006
Posts: 113
Likes: 0
distributor question
I have an hei dis. vac adv. with 9mm ford racing wires my quetions is what can I do to get better performance out of my hei its on a 1988 ford truck converted to carb setup. I have a 600 vac. sec holley and when I install new plugs what gap should I use.
Moderator
Joined: Jan 2001
Posts: 56,997
Likes: 2,742
From: Virginia
Not much you can do, unless you want to go with a MSD box. The system you have now is pretty good.
If you want to leave your plugs in for a long time, I would gap them to the factory specs, which I think is around .045. If you want to change them more often, you could go up to .060.
If you want to leave your plugs in for a long time, I would gap them to the factory specs, which I think is around .045. If you want to change them more often, you could go up to .060.
Thread
Thread Starter
Forum
Replies
Last Post
351Cleveland C4
1967 - 1972 F-100 & Larger F-Series Trucks
19
Aug 20, 2013 07:12 PM
dmack91
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
Nov 19, 2012 01:54 PM
CRUNKED77FORD
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
11
Aug 25, 2011 02:18 PM
