4.9 L I-6 Performance
Thread Starter
|
New User
Joined: Nov 2006
Posts: 10
Likes: 0
4.9 L I-6 Performance
Hey guys,
1993 F-150 2WD.
I-6 (4.9L) w/Fresh new E4OD.
Looking for some Ideas for performance mods.
Will be doing a lot of Highway driving, and pulling Horse trailer on weekends.
will consider bolt on options, looking for a little more performance, and of course MPG boost.
CHIP?
Performance injectors?
What's your take on it?
Thanks,
Michael
1993 F-150 2WD.
I-6 (4.9L) w/Fresh new E4OD.
Looking for some Ideas for performance mods.
Will be doing a lot of Highway driving, and pulling Horse trailer on weekends.
will consider bolt on options, looking for a little more performance, and of course MPG boost.
CHIP?
Performance injectors?
What's your take on it?
Thanks,
Michael
Freshman User
Joined: Jan 2007
Posts: 36
Likes: 0
I put a Flowmaster 40 Series on my Staight 6, sounded pretty good when you step on the gas. Then, I cut my rear cat, I am no saying do this, but I did it anyway. Allot more rumble. I am planning to cut my first cat and gut it out, I was told my motor can't breath because of the cats. I don't care what everyone thinks about cutting the cats, it's my truck not theirs...
As far as the Flowmaster goes, I can notice a difference in speed at mid-high rpm and torque. Just do what you want to do on your truck don't let people dictate you.
As far as the Flowmaster goes, I can notice a difference in speed at mid-high rpm and torque. Just do what you want to do on your truck don't let people dictate you.
More Turbo
Joined: Jul 2005
Posts: 579
Likes: 7
From: Auburn, CA
