Pushrod Length Question..
Thread Starter
|
New User
Joined: Apr 2006
Posts: 12
Likes: 0
Pushrod Length Question..
i am doing a 302 rebuild on a 1986 Block Using a set of 1985 E5AE CA heads. Ordering a cam kit from comp cams and wonder how to figure the correct length for new pushrods. Rocker arms are OE and most of the valve train except for the new springs. I just wondered how to arrive at the correct pushrod length? Gross valve Lift on the cam will be 0.510 intake /0.512 exhaust.
<!-- / message -->
<!-- / message -->
Postmaster
Joined: Jun 2005
Posts: 2,656
Likes: 1
I would think you could just order stock replacement pushrods for a non-roller motor
read this.....
http://www.compcams.com/information/Products/Pushrods/
read this.....
http://www.compcams.com/information/Products/Pushrods/
New User
Joined: Jan 2007
Posts: 4
Likes: 0
Thread
Thread Starter
Forum
Replies
Last Post
CLR f-150
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
Feb 7, 2012 08:45 PM
tbm3fan
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
8
May 18, 2007 01:51 AM
