48-56 Bumper bolt sizes
Thread Starter
|
Post Fiend
Joined: Feb 2001
Posts: 6,328
Likes: 124
From: Iowa
48-56 Bumper bolt sizes
(Ken, feel free to nuke this post if I am stepping over the line here. I don't know how else to get the info timely).
I need to know the carriage bolt diameters and lengths for bumper bolts. Both stock and aftermarket which seem to vary some by manufacturer. I sell and trade polished and satin stainless on the internet and want to make sure I have all potential sizes in stock. No offers to purchase here. This message board is not a swap meet forum so please go to my FTE website or use the email below to contact me. Failure to comply is surely going to earn me a pants down e-Spanking from Ken so lets not go there. :-)
Thanks
Dewayne Reding
53 F100
dewaynereding(No Email Addresses In Posts!)
http://www.clubfte.com/users/fatfenders/index.html
I need to know the carriage bolt diameters and lengths for bumper bolts. Both stock and aftermarket which seem to vary some by manufacturer. I sell and trade polished and satin stainless on the internet and want to make sure I have all potential sizes in stock. No offers to purchase here. This message board is not a swap meet forum so please go to my FTE website or use the email below to contact me. Failure to comply is surely going to earn me a pants down e-Spanking from Ken so lets not go there. :-)
Thanks
Dewayne Reding
53 F100
dewaynereding(No Email Addresses In Posts!)
http://www.clubfte.com/users/fatfenders/index.html
Thread
Thread Starter
Forum
Replies
Last Post
Buckarcher
General NON-Automotive Conversation
24
Jun 16, 2003 09:21 PM
badboyina67
Ford Inline Six, 200, 250, 4.9L / 300
4
Jun 17, 2002 07:26 AM
