I'd like to find a 390 but if not let me know if you got a 360 cause I might have a line on a 390 crank and rods so I could make a 360. Reason I'd want the other 360 is so my 75 isn't down getting a new motor for as long as it will take me to finish the motor.

 

I have a 360 that needs rebuilding you can have e-mail me I live in lino lakes

 

have far is lino lakes from me?

 

i have a few not shure if they run? but they do spin over and i was told they run i also have some intakes and mis fe parts i am getting rid of all my fe stuff so hit me up if intersted trades welcome

 

unfotunatly I don't know where you live. Lino Lakes is a northern suburb of the twin cities right on 35W and 35E just a little norh of Blaine and south of Forest lake

 

oops forgot to say I live in mankato ha I'll keep in touch with ya.

 

if you want closer place theres Joe's auto sales in hastings which is all Ford 1990 and older

 

you still intersted in my fe parts?

 

Got a 390 pro built to 427. Many K invested. will sell cheap before Xmas. PM or e mail me its almost free. Oh less than a thousand miles on it.

 

I didn't see your location until I pm'd you.. you are pretty far away man I am not willing to go that far lol

 

backwoodspuller how much for the heads? What kind are they again?

 

good thing you reminded me i have been very busy latly i will check in the morning and pm you with them i know i have a set off a 390 and 360

 

are they just stock heads? Or aftermarket?

 

Find anything out yet?

 

i looked today i have 2 sets of heads both numbers are
C8AE-H both are on motors both motors spin over i just pulled one motor i was told the motor ran fine but it hasnt been running in a few yrs it still has green antifrezz in it and spins over with no noise that i can hear it dosent have a alt or carb but i would be will to let the whole motor go cheap or trade for some bif block heads i am looking for eather C8VE C9VE or DOVE heads complete would be good let me know thanxs
jesse