Snow Blower Help
Thread Starter
|
Junior User
Joined: Nov 2002
Posts: 63
Likes: 0
From: Plymouth USA
Snow Blower Help
Have a Toro 2-cycle snow blower. Had lawnmower place rebuild carburator (off snowblower) with a new float, needle and seat. Starts OK but then when running it just dumps a lot of raw gas into the cylinder and it floods out and dies. Gas dripping on outside of cylinder and ground. Gravity feed gas supply, no pump.
Any suggestions??????????
Any suggestions??????????
Senior User
Joined: Nov 2005
Posts: 286
Likes: 0
filter between tank and carb----if not --piece of trash may have got between needle and seat--or the shop may not have it right----take it back to them--and dont be surprised if they charge again because something in in seat--get filter in there--or--the float may be bad--
Thread
Thread Starter
Forum
Replies
Last Post
Aftrmidnite
General NON-Automotive Conversation
7
May 18, 2010 09:43 PM
