power source for EGT
Thread Starter
|
Posting Guru
Joined: Jan 2004
Posts: 1,679
Likes: 0
power source for EGT
hey guys,
I need to relocate my EGT power to an ignition power source. This way its not active all the time. Where is a good easy access wire to tap into, so that the guage turns on when the ignition is on?
Tim
I need to relocate my EGT power to an ignition power source. This way its not active all the time. Where is a good easy access wire to tap into, so that the guage turns on when the ignition is on?
Tim
Posting Guru
Joined: Jul 2006
Posts: 1,346
Likes: 0
From: Visalia CA
just remove the panel under your steering, and trace the wire from your ignition, use a test light to find the right one, I dont remember which color wire I used. Should take you 5min to relocate, very easy!!!
Tuned
Joined: Jan 2005
Posts: 305
Likes: 1
From: Delphos, OH
Where to connect electrical for EGT
I hooked my EGT to the builder wires under the dash on the right side as you sit in the driver seat. I removed the fuse panel and they were hanging there with a sticker that says builder. Hope this helps. I just turned the key on and probed with a test light then shut the key off to be sure it was switched.
