EBPV Now ya Done it

Reply Subscribe

Thread Tools

Search this Thread

Aug 25, 2006 | 02:19 PM

NAMDROF

Thread Starter

Mountain Pass

Joined: Jul 2005

Posts: 165

Likes: 5

EBPV Now ya Done it

Hey a BIG THANKS to all that gave great insight on the rebuild on my early 99 7.3 F350 4X4 CC LB EBPV rebuild! And a BIG THANKS to JTHARVEY! What a simple solution to what seemed to cause angst for sure. I tried several ways to connect the EBPV actuation arm to the pin while the turbo was on the pedestal but nothing worked till JTHARVEY suggested his trick of hooking the pin into the actuating arm as you lower the turbo into place. After hours of fussing with this little part of the R&R I followed his lead and sure enough wango zee tango! DONE! A BIG THANKS again for all that gave advice! Maybe someone will be doing a search and find this tidbit of info a time saver down the road!

THANKS
Namdrof

Aug 25, 2006 | 02:39 PM

PowerstrokeJunkie

Post Fiend

Joined: Jul 2005

Posts: 14,582

Likes: 12

From: 21791

that is the technique, it was how i did it when i installed the turbo the three times i put it on with the EBPV.

did you leave repuation points where it is deserved?