Truck pulled up 2 codes today
Thread Starter
|
Junior User
Joined: Mar 2006
Posts: 69
Likes: 0
Truck pulled up 2 codes today
I got a Edge-Evolution Programmer and today I did a run to see if there were any codes and it pulled up 2 of them
1.) P0603-PCM Processor Keep Alive Memory (KAM) Error
2.) P0470- Exhaust back pressure sensor circuit malfunction
Could you all tell me what all this means and what do I need to do to correct this.
Thanks Guys!
1.) P0603-PCM Processor Keep Alive Memory (KAM) Error
2.) P0470- Exhaust back pressure sensor circuit malfunction
Could you all tell me what all this means and what do I need to do to correct this.
Thanks Guys!
Postmaster
Joined: Jun 2005
Posts: 3,438
Likes: 0
From: New Hampshire
The P0470 is a common code usually reulting from a bad EBPV sensor or a tube filled with dry soot. Pull the sensor off and blow out the tube with air. The sensor is located by the left front engine near the waer pump. It sits on a brass colored tube running from the right exhaust bank(passenger side).
Nut
Nut
