Welding perches in
Thread Starter
|
Senior User
Joined: Sep 2005
Posts: 237
Likes: 0
From: mankato, MN
Welding perches in
I'm welding perches on a rear dana 70. I was wondering what the best way is to make sure my perches are at the right angle when i weld them on so my pinion is correct. I have the original axle w/perches so i can go off of that. Thanks
country
country
Elder User
Joined: Jan 2006
Posts: 544
Likes: 0
I prefer to use an angle finder. You can get them for $20 for an Empire, or about $5 for a cheap one. Cut one perch off, then weld the new one on matching angles from the new one to the old one. Then do the other, again setting both at the same angle before welding.
Its also a very handy toos (sometimes required) for doing any driveline, lift, and axle modifications
Its also a very handy toos (sometimes required) for doing any driveline, lift, and axle modifications
