Bronco II Ford Bronco II

4.0 A4ld ???

Reply Subscribe

Search this Thread

Old

Jan 11, 2006 | 03:36 PM

#1

tornacl90rx7

Thread Starter

|

New User

Joined: Jan 2006

Posts: 4

Likes: 0

4.0 A4ld ???

Does anyone know if I can pull the A4LD out of a 4.0 Explorer/ranger and just plug it right in to my '89 B2 with a 2 .9 and electronic T Case ... I ahve been looking for a solution to my the A4LD that is in it now but after wading thru 50-60 pages of posts was unable to find a good answer as what trannies I could use and the 4.0 A4LD seems to be the best so far ...thanx for any hepl and advice ...

Gregg

Last edited by Ken00; Jan 11, 2006 at 07:48 PM.

Reply

Old

Jan 11, 2006 | 05:19 PM

#2

oppy

Laughing Gas

Joined: May 2003

Posts: 1,136

Likes: 1

From: Scenic Wisconsin

I'd say yes. It would certainly bolt in, but you may have to do some minor wire splicing (not even sure of that).

I have heard the 4.0 A4s were a (little) bit stronger.

Reply

Old

Jan 19, 2006 | 11:58 PM

#3

digitydan

New User

Joined: Apr 2005

Posts: 18

Likes: 0

Iwent the opposite way, BII to '92 Explorer. Simple swap, no wiring issues.

Reply

Old

Jan 20, 2006 | 11:13 AM

#4

Monty06

Posting Guru

Joined: Aug 2004

Posts: 1,167

Likes: 1

From: miami florida

b2 a4ld are strong but explorer are stronger only thing your going to come up with is your b2 is one solenoid valve body explorer have two solenoid which controls tc lockup .

Reply

Old

Jan 20, 2006 | 08:28 PM

#5

tornacl90rx7

Thread Starter

|

New User

Joined: Jan 2006

Posts: 4

Likes: 0

But yuo can buy the electronic control unit for the 4.0 A4LD right ??

Gregg

Reply

Reply Subscribe

Tags

3, a4ld, control, ford, strong, unit, wiring

Reply Share

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 08:29 AM.