frontend match
Thread Starter
|
New User
Joined: Feb 2004
Posts: 24
Likes: 0
From: Phoenix
frontend match
I have an 89 E250 with a real bad king pin on the pass side and can't get it out,we broke a 12 ton press trying.I went to the u-pull-it yesterday to get the hole I-beam but they didn't have any 250's,they had two 85 350's and they look alike but I don't want to tear everything apart to find out that there not.can someone please varify for me TIA.
Post Fiend
Joined: Jun 2002
Posts: 13,873
Likes: 3
From: Atlanta GA
$50 sounds like a good deal. Not really something someone would know unless they happened to do a swap like you did or have an interchnage book like the junkyards have.
When I have these type of questions, I try to find the numbers on the parts, then see if they match or if the old number was upgraded to the new number. Which usually means a walk to the local parts counter.
When I have these type of questions, I try to find the numbers on the parts, then see if they match or if the old number was upgraded to the new number. Which usually means a walk to the local parts counter.
Thread
Thread Starter
Forum
Replies
Last Post
