gas fill relocation
Thread Starter
|
New User
Joined: Sep 2005
Posts: 7
Likes: 0
gas fill relocation
i have set up my bronco to relocate the place where to fill up the gas tank i would like it behind the rear driver tail lite but i dont kno how to go about it and i already welded the original spot for it and i dont wanna turn back any ideas on this
send a direct email subject as GAS to stangbuff72@yahoo.com
lookin for ideas on how the rear tail lite will open for this as well and it also needs to pass for safety
thanx guys
send a direct email subject as GAS to stangbuff72@yahoo.com
lookin for ideas on how the rear tail lite will open for this as well and it also needs to pass for safety
thanx guys
Lead Driver
Joined: Sep 2002
Posts: 9,182
Likes: 12
From: Gateway to the West
For safety purposes, you may well have an issue with the wiring harness being too close to open gasoline fumes running it behind the taillight assembly unless you can seal the taillight sockets and wiring. I'm not sure what the actual deal is but I know there is a reason that electronic fuel door releases have gone the way of the Dodo and their contemporaries use a cable release.
Senior User
Joined: Nov 2004
Posts: 168
Likes: 0
From: North Carolina
Sorry to sound like a *** here but why in the hell would you even bother with such a mess ok you welded the original door shut so until you figure this out I assume your not going far due to the fact that you can't put gas in your truck wow people come on now
