Where to ground?
Postmaster
Joined: Jul 2004
Posts: 3,624
Likes: 1
From: Bixby, OK
Get the ground as close as you can to the amp, then just peal up a little carpet (depends on how you wanna do it) and find a good connection to the chassis. I would find a bolt hole, or create your own, expose bare metal and when putting the bolt through, use a star washer. Voila! Ground.
Thread Starter
|
New User
Joined: Jul 2005
Posts: 14
Likes: 0
MB Quart 12" Reference Sub in a sealed .87 cu .ft. box. Dual 2 ohm voicecoil running in parallel (aka 1 ohm).
Amp is a Directed 5-channel pushing 80 watts x 4 into JL Audio XR seperates front and rear (6x8) and 650 watts x 1 into the sub. It hits REAL hard.
Amp is a Directed 5-channel pushing 80 watts x 4 into JL Audio XR seperates front and rear (6x8) and 650 watts x 1 into the sub. It hits REAL hard.
Thread
Thread Starter
Forum
Replies
Last Post
78Ranger_GARedNeck
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
12
Jun 6, 2008 11:39 AM
Ford scooter
Electrical Systems/Wiring
0
Apr 28, 2004 03:51 PM
