Questions about replacing ignition switch?
Thread Starter
|
Senior User
Joined: Aug 2003
Posts: 128
Likes: 0
From: Webster, TX
Questions about replacing ignition switch?
Has anybody every changed out their ignition switch? Do I need any special tools? I found a sight online about changing one on a Mustang and they said that you need a special T-27 tamper resistant torx bit. It is one of the torx bits that has the hollow center? I just wanted to know if I should get one of the bits before I take the column and everything apart.
Thanks,
Nuts4Hotwheels
1988 Clubwagon XLT 351W 5.8L EFI
Thanks,
Nuts4Hotwheels
1988 Clubwagon XLT 351W 5.8L EFI
New User
Joined: Aug 2004
Posts: 13
Likes: 0
There is a small hole below the lock cylinder that you'll need to locate(on the steering column). Turn the ignition key to the 'run/acc' position and stick something up this hole (like a narrow punch, clothes hanger end, etc.) to disengage the cylinder lock mechanism. The whole unit then slides right out.
Mine is an '85, but yours should be the same. Hope this helps.
Mine is an '85, but yours should be the same. Hope this helps.
