It's done...finally
Thread Starter
|
More Turbo
Joined: Nov 2003
Posts: 748
Likes: 28
It's done...finally
79 460 
(Trailer Special) Built it for torque.
rebearing and rings with new STD pistons(just needed hone job)
blanced crank,rods and pistons,also hi-flow oil pump
This cam with new springs,retainers and ARP keepers
http://cranecams.com/index.php?show=...41&lvl=2&prt=5
Ported out the heads(big holes in the exhaust now) bowl blend the intake side
New seats for the intake,3 angle vavle job and the other goodies(guides,seals)
Doug Thorly headers/2.5 exhaust with no cat(all smog stuff gone)
Rebuilt C-6 and drive line.
Right around 2500-2800$ for parts and machaine work
It's been a hell of a project,but it's done.Just have to break it in and go!!
On to the next project.
Can anybody do a desk top dyno for me.I'll go have it dynoed after 2-3k on it.
(Trailer Special) Built it for torque.rebearing and rings with new STD pistons(just needed hone job)
blanced crank,rods and pistons,also hi-flow oil pump
This cam with new springs,retainers and ARP keepers
http://cranecams.com/index.php?show=...41&lvl=2&prt=5
Ported out the heads(big holes in the exhaust now) bowl blend the intake side
New seats for the intake,3 angle vavle job and the other goodies(guides,seals)
Doug Thorly headers/2.5 exhaust with no cat(all smog stuff gone)
Rebuilt C-6 and drive line.
Right around 2500-2800$ for parts and machaine work
It's been a hell of a project,but it's done.Just have to break it in and go!!
On to the next project.
Can anybody do a desk top dyno for me.I'll go have it dynoed after 2-3k on it.
