Need Help Asap
Thread Starter
|
Junior User
Joined: Jun 2002
Posts: 80
Likes: 0
From: Puerto Rico
Need Help Asap
Hello guys. I'm writing cause I bought the mass air conversion kit for my 88 Bronco, but i either lost or i didn't come with instruction. PLEASE point me out to where I can get the instructions on how to install it all with harnesses, cables, etc. Either reply or send me and email, I need it ASAP...thanks... 
Senior User
Joined: Sep 2003
Posts: 257
Likes: 0
I've been thinking about doing a mass air conversion. I hope you've found an installation guide by now Himura77. Did you try asking the company you bought the kit from to mail one to you?
How did the installation go/ how much did you pay. I'm looking to build up my new motor similar to yours, so any input would be helpful. Ex: buy this, stay away from that... thanks,
ctch88
How did the installation go/ how much did you pay. I'm looking to build up my new motor similar to yours, so any input would be helpful. Ex: buy this, stay away from that... thanks,
ctch88
Thread Starter
|
Junior User
Joined: Jun 2002
Posts: 80
Likes: 0
From: Puerto Rico
installation went well, but little hard, and due to not having the instructions that came with the parts, i had to call ford to make sure i had everthing, cause the check engine light came on when i started the car. it was just the map sensor. i did buy a new diablo ship for the EEC-IV computer. she feels the same as before...runs good, and couldn't really tryout if there's a big difference with the fuel consumption
